Cleaning the product

When the product is dirty, wipe it with a soft cloth, such as the one used to clean eyeglasses, to protect the unit from scratches.
If dust is piling up inside the pod, remove the front cover and clean the inside.
Remove the front panel
1
Slide both the left and right outer pillars upward and remove them outward.
2
Remove both the left and right maintenance panels.
3
While slightly opening the front panel to the left and right, remove the panel towards the front.

*

Be careful not to get your fingers caught.

4
Clean the inside using a compression air duster, etc.
Do not use thinner, benzene, or household detergent since they can damage the resin transparency.
Attach the front panel
1
Attach the front panel while slightly opening it to the left and right.
Increase the width to simultaneously fit the cover into the left and right grooves.

*

Be careful not to get your fingers caught.

*

Be careful not to overpower the product.

2
Attach both the left and right maintenance panels.
The positions of the maintenance panel boss differ between the left and right, and the top and bottom positions are also specified.
3
Insert the boss of the outer pillars into the holes on the attaching part and push them downward.
▲ PAGE TOP